Standard Guide to Testing Solvent-Borne Architectural Coatings
This guide covers the selection and use of procedures for testing solvent-borne coatings to be used on exterior, interior or both types of surfaces (see Note 1). The properties that can be examined or, in some cases, the relevant test procedures are listed in Table 1 and Table 2.
Note 1—The term “architectural coating” as used here combines the definition in Terminology D16 with that in the FSCT Paint/Coatings Dictionary, as follows: “Organic coatings intended for on-site application to interior or exterior surfaces of residential, commercial, institutional, or industrial buildings, in contrast to industrial coatings. They are protective and decorative finishes applied at ambient temperatures. Often called Trade Sales Coatings.”
Note 2—Architectural coatings that are designed to give better performance than most conventional coatings because they are tougher and more stain- and abrasion-resistant are covered by Guide D3730.
The types of organic coatings covered by this guide are as follows:
- (1) Type 1 Interior Low-Gloss Wall Finish,
- (2) Type 2 Interior Gloss and Semigloss Wall and Trim Enamels,
- (3) Type 3 Exterior House and Trim Coatings, and
- (4) Type 4 Floor Enamel, Exterior and/or Interior.
Each is intended for application by brushing, rolling, spraying, or other means to the materials appropriate for its type, which may include wood, plaster, wallboard, masonry, steel, previously painted surfaces, and other architectural substrates.
The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Taber® Rotary Abraser - Model 1700/1750
“Taber Test” delivers reliable data in minutes. Used to evaluate a material’s resistance to wear, a flat specimen...
Taber Rotary Abraser 5135 & 5155
The Taber Abraser (Abrader) is used to conduct accelerated abrasion and wear resistance tests on flat specimens. Samples...